|
The
sample storage cassette
is approved for use with the with the Stanford Automated Mounting
system used at SSRL protein crystallography beam lines.
(For more information visit:
smb.slac.stanford.edu/hardware/SAM).
The cassette
is a hard anodized aluminum cylinder (64 mm diameter x 130 mm high)
containing 96 sample ports. Cassettes for online purchase are
black. Other colors are available for large scale orders.
Contact Richard Howells for more information on custom orders.
Calibration / alignment cassettes
are used to calibrate the SSRL Sample Automated Mounting System.
These are made to tighter tolerances than regular cassettes and
contain only two rows of ports. Do not
purchase alignment cassettes for sample storage or shipping.
Sample
pins are held into the sample cassette ports by nickel coated NdFeB
ring magnets (10.4 mm OD,
7.6 mm ID x 2.5 mm).
These magnets are held in place by removable
polycarbonate washers.
Replacement cassette magnets and washers are available for online
purchase (left side of this page).
Each
sample storage cassette
accommodates 96 samples and is compatible with 18 mm
magnetic sample pin bases
and 18 mm magnetic sample pin
bases
with copper post (shown
below with crystal mount tubes installed).
Cassettes may be purchased with sample pin bases (upper left) or
sample pins may be purchased individually (below).
Crystal mount tubes and loops/mounts
are not included with purchase of pin bases.
96 Copper Magnetic Sample Pin Bases
(without mounting tubes and loops)
Part number: CP-111-014-100
$270.00 (or $2.70/each)
96 Magnetic Sample Pin Bases
(non-copper without mounting tubes and loops)
Part number: CP-111-015-100
$270.00
(or $2.70/each)
| 